I’m having a bit of a bizarre issue currently where if I attempt to configure a modbus device with modbus TCP utilizing an ethernet cable, all of the tag qualities change between unknown and the normal value and the device itself seems to begin malfunctioning, with the display screen on it showing a…

First thing would be to disable the use of writing ,multiples, as some devices do not have the full Modbus instruction set implemented. If that doesn’t fix it, be sure to turn them back on as they potentially save a LOT of overhead.

Also keep in mind that some low-end devices might only allow one “user” of Modbus TCP at a time, or a small number at a time.

Inductive Automation Forum

Issue connecting via Modbus TCP to a modbus device

Ignition

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled