# Adjusting alert setpoints

**URL:** <https://forum.inductiveautomation.com/t/adjusting-alert-setpoints/1187>\
**Category:** Archived Topics\
**Created:** [June 19, 2009, 11:59pm UTC](https://forum.inductiveautomation.com/t/adjusting-alert-setpoints/1187 "2009-06-19T23:59:37Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Henry](https://avatars.discourse-cdn.com/v4/letter/h/df705f/32.png) [@Henry](https://forum.inductiveautomation.com/u/Henry)\
**Post date:** [June 19, 2009, 11:59pm UTC](https://forum.inductiveautomation.com/t/adjusting-alert-setpoints/1187/1 "2009-06-19T23:59:37Z")

</div>

I would like to be able to display the alarm alert set point and give the operators the ability to change them. However, I’m not sure in which table they are stored in or how I would access to them. In addition I would like to be flash the text red when it is in an alarm state.

---

<div class="post-metadata">

**Author:** ![Carl.Gould](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/carl.gould/32/7262_2.png) [@Carl.Gould](https://forum.inductiveautomation.com/u/Carl.Gould)\
**Post date:** [June 22, 2009, 4:26pm UTC](https://forum.inductiveautomation.com/t/adjusting-alert-setpoints/1187/2 "2009-06-22T16:26:25Z")

</div>

I think the SQLTags alarm editing goodie available here:  
[inductiveautomation.com/prod … ies/?id=17](http://www.inductiveautomation.com/products/factorypmi/goodies/?id=17)  
will point you in the right direction.