# Alarm Pipeline (Stuck) **URL:** \ **Category:** Ignition\ **Created:** [August 10, 2017, 12:05pm UTC](https://forum.inductiveautomation.com/t/alarm-pipeline-stuck/15029 "2017-08-10T12:05:33Z")\ **Posts on this page:** 2\ **Page:** 1
**Author:** ![bfearnow](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/bfearnow/32/3337_2.png) [@bfearnow](https://forum.inductiveautomation.com/u/bfearnow)\ **Post date:** [August 10, 2017, 12:05pm UTC](https://forum.inductiveautomation.com/t/alarm-pipeline-stuck/15029/1 "2017-08-10T12:05:33Z")
I have an alarm pipeline that is continuously sending out blank messages. The message I want it to send is on the tag’s alarm properties. It works fine for a while and then quits. On the gateway I get the following: ![](https://us1.discourse-cdn.com/inductiveautomation/original/2X/c/c88b4f70f0c77f503abb847b3da041f1524a4841.png) Cancelling does not change. Right now, I am going to try removing the splitter block and see what happens. Anyone have similar issues? (7.9.3) Thanks. ---
**Author:** ![nskoog](https://avatars.discourse-cdn.com/v4/letter/n/ebca7d/32.png) [@nskoog](https://forum.inductiveautomation.com/u/nskoog)\ **Post date:** [September 6, 2017, 10:19pm UTC](https://forum.inductiveautomation.com/t/alarm-pipeline-stuck/15029/2 "2017-09-06T22:19:37Z")
We have a similar problem that is fixed temporarily by restarting the gateway 😧. We had a whole list of emails stuck in the pipeline, showing “Notifying user xxx” in the status, time in block up to 4 days. Only difference is it didn’t send out anything. I noticed the note below in the 7.9.4 change log, maybe it was addressed? The change log note seems to specify redundancy installs, which we don’t have on this particular install. ![](https://us1.discourse-cdn.com/inductiveautomation/original/2X/1/15fcac72f726fa19890309dbdc929061a9e476f1.png)