# Changing the angle on part of my symbol messes up the X/Y coordinates of it over time? **URL:** \ **Category:** General Discussion\ **Created:** [August 20, 2021, 2:14pm UTC](https://forum.inductiveautomation.com/t/changing-the-angle-on-part-of-my-symbol-messes-up-the-x-y-coordinates-of-it-over-time/50140 "2021-08-20T14:14:24Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![WillMT10](https://avatars.discourse-cdn.com/v4/letter/w/7feea3/32.png) [@WillMT10](https://forum.inductiveautomation.com/u/WillMT10)\ **Post date:** [August 20, 2021, 2:52pm UTC](https://forum.inductiveautomation.com/t/changing-the-angle-on-part-of-my-symbol-messes-up-the-x-y-coordinates-of-it-over-time/50140/2 "2021-08-20T14:52:54Z")
This forum topic may help you: > [@Fans Float off Page after some time](https://forum.inductiveautomation.com/t/fans-float-off-page-after-some-time/34671): > > Hi there, I am having an issue with an animation I am doing of a fan spinning on some evaporators. I made it into a template. It works fine only problem is after some time the fans actually start to move off the spot and eventually just float off the screen. I am using the signal generator to get them to spin smoothly and have it set as ramp. If I go off the page and come back the fans go back to there spot. It was working fine on Ignition 7 but now on 8 it started doing it again. Anyone else e… --- _[View the full topic](https://forum.inductiveautomation.com/t/changing-the-angle-on-part-of-my-symbol-messes-up-the-x-y-coordinates-of-it-over-time/50140)._