# Component Equal Scaling using Handles

**URL:** <https://forum.inductiveautomation.com/t/component-equal-scaling-using-handles/45398>\
**Category:** Ignition\
**Created:** [April 8, 2021, 4:44pm UTC](https://forum.inductiveautomation.com/t/component-equal-scaling-using-handles/45398 "2021-04-08T16:44:18Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![jwilliams](https://avatars.discourse-cdn.com/v4/letter/j/c2a13f/32.png) [@jwilliams](https://forum.inductiveautomation.com/u/jwilliams)\
**Post date:** [April 8, 2021, 4:44pm UTC](https://forum.inductiveautomation.com/t/component-equal-scaling-using-handles/45398/1 "2021-04-08T16:44:18Z")

</div>

I am trying to make a 180 degree turn using two separate 90 degree turns. The template for these turns is setup as a 1:1 scale, making an equal sized box for the turn. But when I place these turns into a new view, they do not scale equally, even when their width and heights match.  
 ![image](https://us1.discourse-cdn.com/inductiveautomation/original/3X/1/2/12011c40bbf43c8aeaa505d7b50ff3b0d2341fc5.png)  
Here you can see two separate 90 degree turns, that should form a 180 degree turn easily as they are exactly the same other than orientation.  
 ![image](https://us1.discourse-cdn.com/inductiveautomation/original/3X/2/1/218e43ffbb10ab2584dee5e53786c9a4627f5561.png)  
 ![image](https://us1.discourse-cdn.com/inductiveautomation/original/3X/b/6/b6fa878bc6a12a85bafea24dc017ee08ab1f1344.png)  
However, you can see that both of these turns have different hitbox sizes even though their width and height are exactly the same. Is there a way to use the scaling handles to drag and equally scale a component down. (Usually this is done with Shift + mouse).