# Connecting to Eurotherm 2500 processor

**URL:** <https://forum.inductiveautomation.com/t/connecting-to-eurotherm-2500-processor/9669>\
**Category:** Ignition\
**Created:** [February 6, 2015, 10:17am UTC](https://forum.inductiveautomation.com/t/connecting-to-eurotherm-2500-processor/9669 "2015-02-06T10:17:27Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Special\_tec](https://avatars.discourse-cdn.com/v4/letter/s/b5ac83/32.png) [@Special\_tec](https://forum.inductiveautomation.com/u/Special_tec)\
**Post date:** [February 6, 2015, 10:17am UTC](https://forum.inductiveautomation.com/t/connecting-to-eurotherm-2500-processor/9669/1 "2015-02-06T10:17:27Z")

</div>

Does anybody know if you can connect directly to a Eurotherm 2500 Ethernet processor? Are any specific drivers required?

---

<div class="post-metadata">

**Author:** ![Kevin.Herron](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/kevin.herron/32/7259_2.png) [@Kevin.Herron](https://forum.inductiveautomation.com/u/Kevin.Herron)\
**Post date:** [February 6, 2015, 1:52pm UTC](https://forum.inductiveautomation.com/t/connecting-to-eurotherm-2500-processor/9669/2 "2015-02-06T13:52:59Z")

</div>

Looks like you can use Modbus ([eurotherm.com/products/contr … loop/2500/](http://www.eurotherm.com/products/controllers/multi-loop/2500/)). You’ll have to consult the documentation for the device to figure out which Modbus registers map to the data you want. Once you have that information you should be able to use our Modbus driver.