# How to create three needles in a single gauge in ignition designer **URL:** \ **Category:** Ignition\ **Tags:** perspective\ **Created:** [March 4, 2024, 5:51am UTC](https://forum.inductiveautomation.com/t/how-to-create-three-needles-in-a-single-gauge-in-ignition-designer/86740 "2024-03-04T05:51:23Z")\ **Posts on this page:** 1\ **Showing post:** 10
**Author:** ![lrose](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/lrose/32/62724_2.png) [@lrose](https://forum.inductiveautomation.com/u/lrose)\ **Post date:** [March 4, 2024, 12:57pm UTC](https://forum.inductiveautomation.com/t/how-to-create-three-needles-in-a-single-gauge-in-ignition-designer/86740/10 "2024-03-04T12:57:26Z")
Nothing against @Transistor's solution, it defiantly works. However, if you end up needing to have multiple of these "gauge stacks" on a view your performance can drop dramatically. In that case the better solution is to use an SVG solution. > [@Perspective, faster page](https://forum.inductiveautomation.com/t/perspective-faster-page/69885/35): > > Okay, I had a bit of free time today, so here is a complete SVG solution. You could do the Label as SVG text as well, or a gauge needle if you wanted, I haven't gone that far. Just a little example of the power of using the Ignition Designer to add SVG elements. I didn't include the label for the example. Note: All of this (outside of the calculations needed to find the points for the shape) was done inside of the designer (yes I can be somewhat of a masochist at times. rofl). First a s… This was for a simple gauge, but could be modified to produce multiple needles as well. --- _[View the full topic](https://forum.inductiveautomation.com/t/how-to-create-three-needles-in-a-single-gauge-in-ignition-designer/86740)._