# Ignition Maker OPC-UA Micrologix 1100 (ignition 8.0.14)

**URL:** <https://forum.inductiveautomation.com/t/ignition-maker-opc-ua-micrologix-1100-ignition-8-0-14/38340>\
**Category:** Ignition\
**Tags:** ignition80\
**Created:** [September 3, 2020, 3:07am UTC](https://forum.inductiveautomation.com/t/ignition-maker-opc-ua-micrologix-1100-ignition-8-0-14/38340 "2020-09-03T03:07:17Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![jdehart](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/jdehart/32/17840_2.png) [@jdehart](https://forum.inductiveautomation.com/u/jdehart)\
**Post date:** [September 3, 2020, 3:07am UTC](https://forum.inductiveautomation.com/t/ignition-maker-opc-ua-micrologix-1100-ignition-8-0-14/38340/1 "2020-09-03T03:07:17Z")

</div>

Hey Guys,

I can’t remember if I maybe missed it during install, but I’m not seeing the OPC drivers for any rockwell except for (logix V21+). Did the driver for micrologix (1100 in my case), end up by the wayside for maker edition or 8.0+? I picked one up for home use considering how dirt cheap they can be had nowadays.

If I did maybe miss this during the installation, is there a way to get it now without doing a re-install?

---

<div class="post-metadata">

**Author:** ![rbabcock](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/rbabcock/32/13425_2.png) [@rbabcock](https://forum.inductiveautomation.com/u/rbabcock)\
**Post date:** [September 3, 2020, 12:03pm UTC](https://forum.inductiveautomation.com/t/ignition-maker-opc-ua-micrologix-1100-ignition-8-0-14/38340/2 "2020-09-03T12:03:52Z")

</div>

You can install modules from the gateway, or you can run the installer again and perform an ‘upgrade’. There you can select modules you want to have installed. I did check my Maker install, I do have the Micrologix driver available.

---

<div class="post-metadata">

**Author:** ![jdehart](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/jdehart/32/17840_2.png) [@jdehart](https://forum.inductiveautomation.com/u/jdehart)\
**Post date:** [September 3, 2020, 12:18pm UTC](https://forum.inductiveautomation.com/t/ignition-maker-opc-ua-micrologix-1100-ignition-8-0-14/38340/3 "2020-09-03T12:18:59Z")

</div>

Thanks! Felt like a dumb question to ask, but I really couldnt remember leaving off my module list.