# OPC-UA device in simulation mode

**URL:** <https://forum.inductiveautomation.com/t/opc-ua-device-in-simulation-mode/11536>\
**Category:** General Discussion\
**Created:** [April 19, 2016, 10:33am UTC](https://forum.inductiveautomation.com/t/opc-ua-device-in-simulation-mode/11536 "2016-04-19T10:33:29Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![pgmo](https://avatars.discourse-cdn.com/v4/letter/p/d07c76/32.png) [@pgmo](https://forum.inductiveautomation.com/u/pgmo)\
**Post date:** [April 19, 2016, 10:33am UTC](https://forum.inductiveautomation.com/t/opc-ua-device-in-simulation-mode/11536/1 "2016-04-19T10:33:29Z")

</div>

Hi,  
is there a way to put an Ignition OPC-UA device (in my case Allen Bradley) in simulation mode, the same way I could do, if I were using a Kepware device? It would be very useful, when I have to simulate my pages and I have no PLC connected.

Thanks, regards