# Phoenix Contact Inline Controllers **URL:** \ **Category:** Archived Topics\ **Created:** [April 1, 2016, 4:35am UTC](https://forum.inductiveautomation.com/t/phoenix-contact-inline-controllers/11447 "2016-04-01T04:35:39Z")\ **Posts on this page:** 3\ **Page:** 1
**Author:** ![OCD](https://avatars.discourse-cdn.com/v4/letter/o/e19b73/32.png) [@OCD](https://forum.inductiveautomation.com/u/OCD)\ **Post date:** [April 1, 2016, 4:35am UTC](https://forum.inductiveautomation.com/t/phoenix-contact-inline-controllers/11447/1 "2016-04-01T04:35:39Z")
Has anyone connected these to Ignition? ---
**Author:** ![focusengsk](https://avatars.discourse-cdn.com/v4/letter/f/46a35a/32.png) [@focusengsk](https://forum.inductiveautomation.com/u/focusengsk)\ **Post date:** [September 1, 2016, 3:02pm UTC](https://forum.inductiveautomation.com/t/phoenix-contact-inline-controllers/11447/2 "2016-09-01T15:02:52Z")
I would second that. I am currently looking at a project involving the ‘ILC 131 ETH’ module running Modbus/TCP with Profinet. It would be great to hear anyone’s experience working with Phoenix, any issues etc. ---
**Author:** ![d.diaz](https://avatars.discourse-cdn.com/v4/letter/d/e9c0ed/32.png) [@d.diaz](https://forum.inductiveautomation.com/u/d.diaz)\ **Post date:** [June 3, 2018, 10:44pm UTC](https://forum.inductiveautomation.com/t/phoenix-contact-inline-controllers/11447/3 "2018-06-03T22:44:10Z")
> [@focusengsk](#): > > I am currently looking at a project involving the 'ILC 131 ETH' module running Modbus/TCP with Profinet. Hello, I am currently integrating an ILC 350 PN and I have already established a connection with the Igntion TCP / IP Driver. These controllers support communication under Profinet protocol and TCP. To establish communication, you must configure the function blocks IP\_CONNECT IP\_USEND and IP\_RCV. I just do not receive the data frame correctly