# Project on Ignition Edge Gateway

**URL:** <https://forum.inductiveautomation.com/t/project-on-ignition-edge-gateway/94678>\
**Category:** Ignition\
**Created:** [August 14, 2024, 11:26pm UTC](https://forum.inductiveautomation.com/t/project-on-ignition-edge-gateway/94678 "2024-08-14T23:26:01Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![Mitesh\_Maniar](https://avatars.discourse-cdn.com/v4/letter/m/45deac/32.png) [@Mitesh\_Maniar](https://forum.inductiveautomation.com/u/Mitesh_Maniar)\
**Post date:** [August 14, 2024, 11:26pm UTC](https://forum.inductiveautomation.com/t/project-on-ignition-edge-gateway/94678/1 "2024-08-14T23:26:01Z")

</div>

I have ignition project developed on standard ignition gateway and i am sending it to ignition edge gateway (remote gateway) using EAM module. project transfers successfully and i am able to open project on remote gateway in edge designer. but project appears to be distorted graphics and doesn't remain same as it is on my standard ignition gateway (local gateway). any suggestions ?