# View Disappeared After Pull from Remote Repo

**URL:** <https://forum.inductiveautomation.com/t/view-disappeared-after-pull-from-remote-repo/51954>\
**Category:** Ignition\
**Created:** [October 14, 2021, 7:16pm UTC](https://forum.inductiveautomation.com/t/view-disappeared-after-pull-from-remote-repo/51954 "2021-10-14T19:16:29Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Kevin.Herron](https://sea1.discourse-cdn.com/inductiveautomation/user_avatar/forum.inductiveautomation.com/kevin.herron/32/7259_2.png) [@Kevin.Herron](https://forum.inductiveautomation.com/u/Kevin.Herron)\
**Post date:** [October 14, 2021, 7:17pm UTC](https://forum.inductiveautomation.com/t/view-disappeared-after-pull-from-remote-repo/51954/2 "2021-10-14T19:17:52Z")

</div>

Have you changed the scan frequency of your gateway yet?

> [@Ignition projects and Git repo sync issues](https://forum.inductiveautomation.com/t/ignition-projects-and-git-repo-sync-issues/51883/2):
>
> Sounds like you might need to increase the project scan frequency. In 8.1 the default is 5 minutes, which isn’t really suitable if you’re trying to use git. In ignition.conf you can add JVM arg to the additional parameters section: -Dignition.projects.scanFrequency=10 Would set the frequency to 10 seconds.

---

_[View the full topic](https://forum.inductiveautomation.com/t/view-disappeared-after-pull-from-remote-repo/51954)._