Changing the angle on part of my symbol messes up the X/Y coordinates of it over time?

  • I’m using a fan from the symbol factory.
  • I’m changing the angle of the fan over the full 360 degrees using a timer for smoothness. (specifically
    the blades, not the entire symbol.
  • Slowly, over time, the fans decided to spin right off into their own orbit.
  • Sometimes, even the shroud behind the fan would get wonky.
  • I’ve noticed this same issue in tatsoft
  • the position of the symbol as a whole remains unaffected.

Any insight to what might be causing it?

This forum topic may help you:

Sounds like a dodgy product design to me, maybe go back to the fan reseller and claim a warranty issue :grinning_face_with_smiling_eyes: