I’m using the Siemens Enhanced driver with Ignition Edge 8.3.4, but it’s extremely slow. It can take up to 10 seconds to see a tag changing. Below my setup: [image] [image] To try to get it a bit more useable, I troed changing the tag group: Changed the default group to this: [image] I al…

I’ve not used this Siemens Module before but have you double checked all the Tag Configs are using the right Tag Groups, etc? Of course your string values will only change every 10s (as the Tag Group is defined as 10s). Try changing your Default Tag Group’s Mode from using “Leased” to “Direct” and …

That doesn’t change anything unfortunately (I also think that was the default)… Maybe it’s too much for the S7-1200? I don’t know…

It is the default but it should just work to be honest. Have you had a look inside your device setup on the Gateway Webpage?

You can see my device setup in the opening post, are there any other settings I should look into? Any other troubleshooting steps?

As noted over here, it may not be the driver or the PLC... [image] Siemens enhanced driver slow value changes Ignition A update for my situation. The problem has been sovled. The delay was caused by my VM. When running ignition and the siemens enhanched dri…

My guess is that it takes a long time to read the 40 string tags. There's some more info in this thread/reply that may be useful to know. [image] Ignition V8.3 Siemens Enhanced Driver - Slow Update Rate Ignition Thanks Rohan, I had seen your support ticket com…

Siemens Enhanced driver extremely slow

Ignition

Cody_Morgan March 16, 2026, 5:28pm 7

My guess is that it takes a long time to read the 40 string tags. There's some more info in this thread/reply that may be useful to know.