Alert Switch Block

Hey guys,

Am I doing this right? I have a switch block set for {priority} and output values of 3 and 4 but it would never pass any alerts through the pipeline. I did a test and bypassed the switch block with the catch all and then I started getting alerts through the pipeline. Do I just have this block set up incorrectly or is there an issue with it?


Hi,

Yes, it looks like it’s currently only comparing the “name” of the priority, like “low”. However, we’ve changed it for 7.6.1 rc4 to allow for the integer value as well.

Regards,

Oh, I didn’t even think about using the name. Haha. Ok, thanks!