Ignition 8.1.28 61850 able to grab values from Model but not Reports

[Pofer_Wang]

I have encountered the same issue.

I found that when I chose to use REPORT1, even though I confirmed my packets using Wireshark, no data appeared. However, when I chose REPORT6, the data could be received normally.

I have also raised some questions about 61850. You can refer to this post:

61850 Driver MMS Report issues

Hello, I have a few questions about the 61850 REPORT function. As shown in the picture, I selected REPORT 1 and confirmed that RptEna is checked, but I cannot receive the data. [image] [image] If I select REPORT 6, my RptEna is not checked, but I can still receive the data. [image] [image] I see the correct timestamp on the CB stVal, but in the settings, I did not check Report Timestamp. [image] [image] On the contrary, when I check it, the timestamp becomes incorrect. I have alrea…