I downloaded the language switcher demo project from inductiveautomation.com/downloads/extras. I tried to upload it into Ignition 7.6.4 and open it with Designer. From the EditTranslations window, it seems to be desinged for a special project. Is it right? Because there are no Readme or instruction guide, I do not know how to set up the language switch. Does anyone know the basic steps of it?
Thanks & Regards,
I could try to track down the instructions for how that works, but I thought it might be better to first point out that Ignition 7.7 will have built in translation and language switch support, which is much better than the method used in that project. If you’re experimenting or developing a new project, I’d recommend trying that out. You can get it from the downloads page by going to “Early Access” on the left hand side.