Link Ignition with Delta Simulator

Ignition
1

Hi everyone. Thanks for reading me.
I am beginning to create an OPC UA Scada linked with PLC Delta through Modbus TCP.
I cannot acquire the signals coming from the memories and the coils. It always appears this answer with these errors:
image

If I am trying to read the state of those signals, from the Ignition * OPC Quick Client, I get this message:
image

I don't have any idea what is wrong. The platform Designer shows a good connection between Ignition and SImulator Delta.

I registered well the Addresses Configuration for 'PlcDelta':

image
image990×182 8.59 KB

The prefix M is related to the internal variables inside the PLC.

I am Attentive to any solution you could give me

2

Are you sure UnitID = 0 is correct for that application? The Delta docs should say what slave unit ID is appropriate.

3

the reference Unit ID serves the function of differentiating the different groups of existing variables. I can have two groups of "M", I just have to difference with two different Unit ID's reference

4

Hello.

What is the ID for DVP Simulator? Did you resolve it this issue?

Thank you.
Best regards.