Anyone successfully connected Ignition to Mitsubishi FX3U? If so, what method did you use?

Most customers are using Kepware to connect to Mitsubishi PLCs right now.

Hi Emca, Have been successful data updating with Ignition and Kepware (FX3U)? Ignition works fine with Mitsubishi MX OPC server (GX Works2 simulator and PLC either way). I tried to use Kepware, communication is ok, but Quality bad ( data not updating)…

hello. now in version 8.1.31 support the FX3U?? regards

Yes, however you will need a FX3U-ENET module.

Mitsubishi FX3U-ENET Connection Guide for UDP A setup guide for the Mitsubishi Melsec FX3U-ENET Ethernet module. Shows you how to monitor and control an FX3-Series PLC using MC Protocol over UDP with Fernhill SCADA. I tried to follow this configuration but …

You will almost need to merge that configuration, have a look with the setup described in the manual, https://docs.inductiveautomation.com/display/DOC81/Mitsubishi+TCP+Driver#MitsubishiTCPDriver-FXConfigurator

Mitsubishi FX3U

Ignition

Renz_Eran_Santos January 17, 2024, 2:19am 8

I tried to follow this configuration but its not working and this is for a different brand of SCADA, are these parameters also applicable to Ignition?