OPC UA Connection Failure with Siemens Sinumerik One

Hello All,

I have Ignition 8.1 connected with Siemens Sinumerik One NCU1750.
I am using OPC Connections to fetch data from PLC.
My connection status is connected .
When there is new power cycle to PLC and Ignition PC the OPC communication shows as faulted.





To make connection healthy I have to enter passwords in Sinumerik Authentication page and Reboot again .
Then it comes up.
It should be automatically connected all the time.

Is there any settings for this.

Sounds like a Sinumerik question, not an Ignition question. Is there some procedure needed to save your authentication changes on the Sinumerik side to the Sinumerik's persistent memory?

May be ,Need to check this with siemens .